Precautions for processing CNC machining center
The operating voltage fluctuation of the switching power supply of the CNC lathe is small, the normal operating temperature is less than 30 degrees Celsius, and the relative temperature is less than 80%. If the machining center wants to be used normally, it needs to consider many aspects. Here are the following points compiled by Jiujiang Xiaobian:
1. Regulations on the natural environment of the processing center
It is best not to have vibration sources around the machining center, avoid strong direct sunlight and radiant heat, and not be affected by damp and cold, and cyclones. If there is a vibration source around the CNC lathe, then we should set up a vibration isolation ditch around the CNC lathe.
Second, switching power supply regulations
During the assembly and installation process of various components of the machining center, the working voltage of the switching power supply must be strictly controlled. The operating voltage of the switching power supply should be kept stable, within the allowable range, and the adjustable range of the output voltage should be specified.
3. Temperature standard
Generally speaking, CNC machine tools are equipped with industrial coolers or exhaust fans to make electronic components last longer. If the temperature is too high and the humidity is high, the service life of system components will be reduced, and then there will be an increase in equipment failure.
Four, according to the requirements of the application of CNC lathe
In the process of using the CNC lathe, if you don't understand it, don't modify the parameter information about the manufacturer's settings in the control system casually.
The main parameter values can be optimized according to the site conditions, and the machine tool accessories we buy should not be replaced casually. For example, the working pressure of the hydraulic chuck, hydraulic machine tool table, hydraulic machine lathe tool holder, and hydraulic cylinder should be within the allowable stress range, and it is not allowed to increase and replace at will.
The above is related to the "CNC Machining Center Precautions". I hope that friends who have questions about the CNC Machining Center Machining Precautions will be helpful. If you want to know more about the Machining Center, please pay attention to the Shenzhen Jiujiang Technology Machining Center factory.